Samsung J7 J700P Convert To J700F Tested Firmware Flash File

Samsung J7 J700p Convert to j700f

samsung j7 j700p convert to j700f tested firmware flash file

Follow these steps to enter Download Mode/Odin Mode

Power off your device
Press and hold Volume Down key, Home Key and Power Key
When your device vibrates, release Power key while keep holding the Volume Down key and Homekey
Press Volume Up key to enter Download mode, which has a green robot figure and “Downloading… Do not turn off target!!)
You device should be automatically recognized by Odin. At the lower-left of Odin interface, it should show a message that says “Added!” and in the meantime you should see a light-blue box at the ID:COM section stating “COM:3” (the number depend on which USB port you have plugged the device cable and is irrelevant). Whether it is “PDA” or “AP” depends on the version of Odin that you used. But the md5 file goes to either “PDA” or “AP”. After adding the file, click “Start” to begin the flashing process.
WARNING DO NOT REMOVE OR OPERATE ON YOUR DEVICE UNTIL FINISHED OR FAILED IS SHOWED ON ODIN.
When the flashing process is done and if everything goes well, you should see a big green box saying “RESET” or “PASSED” (depends on the version of Odin is used). By now, the device should be rebooted and it is safe to remove/unplug your device.
Flash succeeded

How To Flash

Follow these steps to enter Download Mode/Odin Mode

Power off your device
Press and hold Volume Down key, tonic key and Power Key
When your device vibrates, release Power key while keep holding the quantity Down key and residential key

Warning before getting into download mode

In the initiative cut your phone by holding the facility key for a cpuple of seconds. Then press and hold together Volume Down + Bixby + Power button a few seconds.
After that, you ought to see a menu with two options. Finally, enter Download Mode by pressing Volume Up

Connect your device to PC.

Your device should be automatically recognized by Odin. At the lower-left of the Odin interface, it should show a message that says “Included! “Added!” and within the meantime, you ought to see a light-blue box at the ID: COM section stating “COM:3” (the number depend upon which USB port you’ve got plugged the device cable and is irrelevant).

Click “PDA” or “AP” to feature the tar.md5 file that you “Start”.

Whether it’s “AP” depends on the version of Odin that you simply used. But the md5 file goes to either “AP”.

Add *.md5 to Odin.

adding the file, click “Start” the flashing process.

After adding the file click start to begin the flashing process

Click “Start” to flash

DO NOT REMOVE OR operate YOUR DEVICE UNTIL FINISHED OR FAILED IS SHOWED ON ODIN.

Ongoing flashing process. don’t remove your device.

When the flashing process is completed, you ought to see an enormous green box saying “RESET” or “PASSED” (depends on the version of Odin is used). By now, the device should be rebooted and it’s safe to remove/unplug your device.